Upgrade your Jeep-s stock rear drum brakes to disc brakes with this high-quality TeraFlex 1991-2006 Dana & Chrysler: Rear Disc Brake Conversion Kit. This bolt-on kit features an internal drum parking brake for outstanding holding power compared to other disc brake conversion kits.

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/product color=12mm X 100,fitment_info=- 1991-2006 Jeep factory Dana 35 C-clip rear axles
- 1991-2006 Jeep factory Dana 44 rear axles
- 1991-2006 Jeep factory Chrysler 8.25" C-clip rear axles
,height=12,installation_time=3 hours,length=24,product_image_size=Default,product_notes=- Does NOT include Emergency Brake Cables (# 4304169).
- Does NOT work w/ ABS sensors. You will NOT be able to install ABS sensors in the disc brake mounting kit.
- Some factory Jeep 15'' wheels may rub on the caliper. Do NOT operate the vehicle until you confirm adequate caliper/wheel clearance.
- Most aftermarket wheels, especially alloy wheels, REQUIRE longer wheel studs when installing a disc brake. Wheel stud specs: 1/2''-20 Serrated Wheel Stud - 0.625'' Knurl, 1-5/8'' Length. Check local parts store.
- You may cut a slot in the pre-load ring and slide it over the axle shaft if you do not want to replace the wheel bearings.
- These disc brake kits REQUIRE axle shafts w/ a 2.5'' bearing offset.
,size=2XL,sw_featured=No,width=13