JL/JT Tera44 Complete Front Axle Shaft Assembly.

Upgrade your JL Wrangler or JT Gladiator factory 44 front axle housing with heavy-duty fully assembled axle shaft assemblies from TeraFlex. Designed for both ARB locker-equipped front 44 housings and factory locker applications, these assemblies are available in both 32-spline and 35-spline configurations.

Each assembly comes pre-built with the inner axle shaft, outer stub shaft, and 1350 U-joint already installed to simplify installation and reduce downtime. Manufactured from high-strength 4340 Chromoly Steel, these axle shafts are built to handle the added stress of larger tires, harder trails, and aggressive off-road use while maintaining factory'style fitment and operation.

These assemblies are a direct fit in the factory 44 housing as well as the Tera44 replacement housing and are also designed to replace factory CV style axle shafts in the original housing. Vehicle Fitment Info Fits Dana 44 front axle applications 2018+ JL Wrangler 2-door 2018+ JL Wrangler Unlimited 4-door 2020+ JT Gladiator Direct replacement for factory CV axle shafts Product Notes Available for both ARB locker and factory locker configurations Left and right-side assemblies sold by application Compatible with factory'style Dana 1350-series U-joints

3334243 Axle Shaft kit JL/JT Rubicon, Front Right 32 Spline Assembly 3334240 Axle Shaft kit JL/JT Rubicon, Front Left 32 Spline Assembly 3334244 Axle Shaft kit JL/JT Front Right 35 Spline ARB Assembly 3334245 Axle Shaft kit JL/JT Front Left 35 Spline ARB Assembly Heavy-duty JL/JT specific front axle shaft assemblies for factory and Tera44 housings. Fully assembled with inner shafts, outer stub shafts, and 1350 U-joints. Built from 4340 Chromoly Steel for strength and durability on and off-road.

• - Fully assembled axle shaft assemblies
• - Includes inner shaft, outer stub shaft, and 1350 U-joint
• - Available in 32-spline and 35-spline versions
• - Compatible with ARB locker and factory locker 44 housings
• - Manufactured from high-strength 4340 Chromoly Steel
• - Uses factory'style 1350 U-joint configuration
• - Designed for increased strength and durability
• - Direct replacement for factory CV shafts and in 44 housings
• - Includes FAD seal surface on the long side shaft

WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/product

SAEJ2492 WARNING: By installing this product, you acknowledge that the suspension of this vehicle has been modified. As a result, this vehicle may handle differently than factory-equipped vehicles. As with any vehicle, extreme care must be used to prevent loss of control or rollover during sharp turns or abrupt maneuvers. Always wear seat belts, and drive safely, recognizing that reduced speeds and specialized driving techniques may be required. Failure to drive this vehicle safely may result in serious injury or death. Do not drive this vehicle unless you are familiar with its unique handling characteristics and are confident of your ability to maintain control under all driving conditions. Some modifications (and combinations of modifications) are not recommended and may not be permitted in your state. Consult your owner's manual, the instructions accompanying this product, and state laws before undertaking these modifications. You are responsible for the legality and safety of the vehicle you modify using these components.